19.11.13

Stripboard PID Arduino Shield, Part 4: Thermocouple Interface

The diagram shows how to connect an Adafruit MAX31855 breakout board to the stripboard Arduino PID shield. Vin should connect to the 5V pin and DO, CS, and CLK to A0, A1, and A2 respectively. Connect a K thermocouple in the screw terminals. If the temperature reading goes down when it should go up, switch the thermocouple wires around.



1 comment:

Anonymous said...

Wondering what changes should I make to put back smaller LCD 8x2 but keep all functions from this version?

Post a Comment